20 / Chapter 3 Installation
1.
PS/2 AT Keyboard port
This connection is for a standard keyboard using an PS/2 plug
(mini DIN) . This connector will not allow standard at AT size
(large DIN) keyboard plugs. You may use a DIN to mini DIN adapter
on standard AT keyboards.
2.
PS/2 Mouse port
This system will direct IRQ12 to PS/2 mouse.
3.
Serial Port COM 1 and COM 2 port
The COM1/2 serial ports can be used for pointing devices or
other serial devices. See "Onboard Serial Port" in chipset Feature
Setup of the BIOS SOFTWARE.
NOTE:
Serial {D-type 9pin (F) } must be connected to the
serial port.
4.
Parallel Printer port
You can enable the parallel port and choose the IRQ through "
Onboard Parallel Port" in Chipset. Feature Setup of the BIOS
SOFTWARE.
5.
Universal Serial BUS Ports 1 & 2
Two USB ports are available for connecting USB devices.
6.
Floppy drive connector
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two
plus on the other end to the floppy drives.
7.
FAN1 , FAN2 CPU Cooling Fan (FAN1,2)
These connectors support cooling fans of 500mAmp
(6Watt) or less. Orientate the fans so that the heatsink fins
allow airflow to go across the onboard heat sink(s) instead
of the expansion slots. Depending on the fan manufacturer,