7. Phase switch
The normal setting for the phase is the 0º position. Switching to 180º will
change the subwoofer phase and vary the tonal quality of the bass, which is
also dependant on the location of the AESPRIT Sub relative to your main
stereo speakers
8. Line in jacks (RCA-type pin-plug)
Used to connect the subwoofer to the PRE-OUT jacks of the amplifier.
9. Line out jacks (RCA-type pin-plug)
Used to connect
back to the power
amp inputs on
your amplifier.
10. From
amplifier-Hi-
level speaker in
terminals
Used to connect
the FRONT
SPEAKER terminals
of the amplifier to
this unit.
11. To speaker-Hi-
level speaker
out terminals
Used to connect
the front speakers
with this unit, via
the 75 Hz 1st-
order crossover.
FRONT PANEL
1. Crossover frequency knob
Adjusts the balance at the crossover point between the bass
(low frequencies) from the AELITE Sub and the treble (high frequencies)
continuing to the main stereo front speakers.
2. Sub level volume control knob
Adjusts the volume level output of the
subwoofer, allowing you to balance the
volume of the AELITE Sub to blend in
with your main stereo speakers.
Turning the knob clockwise increases
the volume level, and turning the knob
counter clockwise decreases the level.
3. Infrared sensor
The sensor must be kept clear to
ensure proper working of the remote
control.
BACK PANEL
4. Power switch
Switches the power ON and OFF. By switching to AUTO the power is
automatically switched ON when a signal is applied to an input.
5. Power indicator light
This indicator lights green when the power is switched ON, and lights red
when in STANDBY mode.
6. Power cord socket
Connect the cord supplied to a 110-120V or 220-240V AC main power
outlets.
Operation
3
ACO
USTIC ENERGY
200W ACTIVE SUBWOOFER
11
8
10
7
Summary of Contents for Aelite Sub
Page 1: ...Owner s manual ...
