MANUALS VIRTUOSO LE
Maribor, Slovenia-EU: October 2020
Page
7 | 11
Figure 1: Connection with single stereo amplifier. Use jumpers/bridges.
Figure 2: Bi-wire connection with single stereo amplifier. Remove jumpers-bridges.
NOTE: For other kind of connections, like bi-amping with multiple amplifiers please use manuals from amplifiers manufacturers.
6.
USING
•
After the correct installation and connection of the speakers, first check the settings of your audio
amplifier/receiver.
•
Never use unprotected/uninsulated jumpers/bridges for connecting the +/+ or -/- connectors, as this
may cause a short circuit.
•
Never insert metallic or conductive objects in connectors for cables.
•
Before use, always check if specification of audio amplifier/receiver meets the requirements of the
loudspeakers (Power, Impedance, Voltage etc.).
•
Make sure that audio amplifier/receiver is initially set to minimum volume and gradually increase to
desired volume.
•
New loudspeakers should NEVER be exposed to high volume initially, since electronic and mechanical
components must burn-in gradually.
•
Never exceed the listening volume which could cause uncomfortable feeling or ear damage.
