Chapter 2: Programming
Chapter 2: Programming
Chapter 2
19
Note:
You can't learn any commands under the SETUP/SHIFT, MACRO, LIGHT or any component keys on the touchscreen.
7. Press and hold the original remote key you want to transfer to the ARR1540 until
Learning Success
appears. This process can take 2-3 seconds to
complete.
Do not move the remotes during the learning process.
8. Release the original remote key. If there is a problem during the Learning process,
Learning Error
appears. If this happens, try adjusting the distance
between the remotes slightly and repeat steps 6-7.
9.
Key Name?
appears, allowing you the option to change the name. Use the up and down arrow keys to choose the fi rst letter, and the left and right
arrows to move to the next letter.
10. When fi nished naming the key, press OK on the touchscreen.
Save Changes?
appears. Press OK again.
Changes saved
appears.
11. Repeat steps 6-10 for other keys to be learned.
12. When all the original remote commands have been learned, press SETUP/SHIFT to save the changes.
Learning Completed
appears.
13. To learn from other remotes, press the component key you want to learn to and repeat steps 6-12.
14. When fi nished, press EXIT. Then press OK to exit the Setup menu.
If
Learning Memory Full
appears when you try to learn a new key, you need to clear the learned memory before you can learn new keys.
•
To clear all learned keys when
Clear All Learning Memory
appears, press the OK key on the touchscreen.
Clearing All Learned Memory
appears. All
learned keys for all components are cleared.
•
To clear only a specifi c set of learned keys for a component, see the Deleting All Learned Keys for a Specifi c Component section on page 20.
•
To exit without clearing any learned keys, press EXIT. Remember, you won’t be able to learn additional keys.
ARR1540 IB.indd 19
ARR1540 IB.indd 19
11/16/04 5:55:04 PM
11/16/04 5:55:04 PM
