Activities
21
A
ctivitie
s
Read about the test
The first screen gives you some information about the test. Use the arrow keys below the
screen to go to the next page.
IMPORTANT:
Make sure all your devices are on before you start.
Test individual power commands
The second screen lets you test the power command you set for each device. Use the
arrow keys to highlight each device, then press
for each device to see if it turns that
device off. (If it does, make sure you turn it back on!) Only the first three devices are
shown on this page. Use the arrow keys below the screen to access the rest of your
devices.
IMPORTANT:
If you notice one of your devices does not respond to the power command,
make a note—you will need to change the power command you give to that device.
Under your last device, there’s is an on-screen
OK
button. Highlight
OK
and press
to
continue with the test.
Test Activity
DirecTV
Harman/K
OK
Test the entire activity
The next screen lets you test the “Good Night” activity with your entire system.
IMPORTANT:
Make sure all your devices are on before you start. Also make sure your
remote is pointed directly at your home theater. Then press
to begin the test. The
screen says “Sending IR Functions” while the remote is sending the power commands.
Test Activity
Begin Test
Throughout the
Activity test, point
the remote
towards
your devices.
Test Activity
Test Again
Reconnect USB to
verify activity.
Did it work?
If it worked (if your devices turned off):
Reconnect the remote to your PC (see the
heading below).
If it didn’t work:
Make sure your remote is pointed directly at your home
entertainment devices and that there’s nothing obstructing the path, then press
to test the activity again.
IMPORTANT:
Make sure all your devices are on before you
start.
Test Activity
Use the power
buttons on the
next page to turn
off or on your
devices in
Good Night.