12
Step 8
Next please adjust the micrometer to the value
figure given on your UNI-template.
You can read down the value on the micrometer’s
scale.
The linear drive will move while you do adjust
the micrometer. It will be moved to the exact
position required for the specific template’s
tangential error curve.
Step 9
Now please take the long clear acrylic position-
ing arm. Insert either the straight pin or the pin
with the round reticle into the far narrow end of
the clear acrylic positioning arm. Tight the pin in
place lightly.
If your tonearm does feature a round bearing
house and/or if you are not sure where the actual
pivot point of your tonearm is, please use the pin
w/round reticle to adjust to the outer dimensions
of the bearing.
In general the pin w/reticle is the better way to
locate the pivot point of your tonearm.
straight pin
pin w/reticle