/
USER GUIDE
WARRANTY INFORMATION AND LEGAL DISCLOSURES
TROUBLESHOOTING
Not Sure if Fully Charged?
Refer to “Effortless
™
LEDs” chart.
Unable to Pair for the First Time?
When you turn on the
module, make sure to continue holding down the button for
a full 5 seconds until you hear ascending tones followed by
a series of beeps. The beeps indicate that the module is in
pairing mode.
Unable to Pair?
If your Bluetooth
®
enabled device is unable
to pair with the Bluetooth
®
module, you may need to reset the
module and/or your device. To reset the Bluetooth
®
module,
turn it on then hold both the “up” and “down” arrow buttons
down for 7 seconds. Once the reset function is complete, there
will be 2 long tones. The Bluetooth
®
module must be turned
off and then turned back on for it to enter into pairing mode.
Unable to Find Device while Pairing?
If your AcousticSheep
®
module was previously paired with another device, it will
automatically pair with that device if the device is within range.
Make sure that the Bluetooth
®
on all other previously paired
devices is turned off when you are pairing with a new device.
No Sound When Paired
• Slide the speakers inside the headband (gray side of
speakers towards the ear) to position them over your ears.
• Check the volume on your Bluetooth
®
audio player and
wireless Bluetooth
®
module located inside the headband.
• Make sure the wireless Bluetooth
®
module is charged.
• If your paired Bluetooth
®
device is separated from your
SleepPhones
®
Effortless
™
headphones for more than 5
minutes, the headphones will automatically power off. Try
powering them back on (not all apps or software support
Bluetooth
®
).
• Turn off the module and restart the pairing process.
AS-E-UG-01
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth
®
SIG, Inc., and any
use of such marks by AcousticSheep LLC are under license. Other trademarks and trade names are those
of their respective owners.
BATTERY
This AcousticSheep
®
product contains a rechargeable lithium ion battery. It should only
be charged with the charging cable and wall adapter provided with this product. Lithium
batteries last longer if they are charged after every use. They do not need (and prefer not)
to be fully discharged before recharging. AcousticSheep
®
provides a battery replacement
and recycling service that you can access through our website. Please DO NOT attempt
to open this product or replace the battery yourself. Opening the product voids the
limited warranty.
WARNINGS
WARNING: SleepPhones
®
or RunPhones
®
may be a strangulation hazard. They should
not be used by children, the elderly, or by anyone who may strangulate on the cord.
WARNING: Use of a headset that covers both ears will impair your ability to hear other
sounds. Use of such a headset while operating a motor vehicle or riding a bicycle may
create a serious hazard to you and/or others, and is illegal in most states and regions.
WARNING: Exposure to high volume sound levels may damage your hearing.
The louder the volume, the less time is required before your hearing could be affected.
You may experience different sound levels when using your headset or headphones
with different music and different devices. If you experience hearing discomfort, you
should stop listening to the device through your headset or headphones and have your
hearing checked by your doctor.
To protect your hearing, hearing experts suggest that you:
• Set the volume control in a low position before putting your headset or
headphones on your ears and use them at the lowest possible volume.
• Avoid turning up the volume to block out noisy surroundings. Whenever possible, use
your headset or headphones in a quiet environment with low background noise.
• Limit the amount of time you use headsets or headphones at high volume levels.
• Turn the volume down if the sound from the headset or headphones prevents you
from hearing people speaking near you.
If you live in North America and still can’t find the information you need, please
call our customer service team for assistance before returning the products to your
retailer under their return policy.
Tel
: 877-838-4790
: service@acousticsheep.com
If you live outside of North America, please visit our website
www.SleepPhones.com
or
www.RunPhones.com
to locate your country’s distributor.
Bluetooth
®
Wireless Headphones
AcousticSheep LLC
FCC NOTICE TO USERS
FCC ID: S9HZJRNFY10
Changes or modifications not expressly approved by AcousticSheep LLC could void the
user’s (or your) authority to operate the equipment. This device complies with part 15
of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For the product FCC registration label, please see the Bluetooth
®
wireless module
contained inside of the headband.
RF EXPOSURE
THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES.
It is designed not to exceed the limits for exposure to radio waves recommended by
international guidelines.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance.
DECLARATION OF CONFORMITY
AcousticSheep LLC declares that this product is in compliance with:
• The essential requirements and other relevant provisions of Directive 1999/5/EC
• All other relevant EU Directives.
In compliance with WEEE Directive (2002/96/EC), please dispose of this
product by taking it to your local collection point or recycling center for
electronic devices.
These statements have not been evaluated by the Food and Drug Administration. This
product is not intended to diagnose, treat, cure, or prevent any disease.
• Limit the amount of time you use headsets or headphones at high volume levels.
• Turn the volume down if the sound from the headset or headphones prevents
you from hearing people speaking near you.
LIMITED ONE-YEAR WARRANTY
Please refer to
www.SleepPhones.com/warranty
for full details regarding the
AcousticSheep LLC Limited Warranty.
CUSTOMER SERVICE
The answers to most setup and performance questions can be found in the FAQs at
www.SleepPhones.com/faqs
or
www.RunPhones.com/faqs
.
Visit
www.SleepPhones.com/instructions
to read this User Guide as well as Warranty
Information and Legal disclosures in additional languages.
Bluetooth
®
Wireless Headphones with Induction Charging
Welcome to the
AcousticSheep
®
Family!
This User Guide has helpful tips and info for
using and enjoying your new AcousticSheep
®
SleepPhones
®
or RunPhones
®
Effortless
™
.
Still have questions? Contact our customer service
team M-F from 8-5pm EST at
877-838-4790
or
at
service@acousticsheep.com
.
Enjoy!
/
/
/
© 2018 AcousticSheep LLC. All rights reserved. SleepPhones
®
, RunPhones
®
, the SleepPhones
®
logo,
the RunPhones
®
logo, and “pajamas for your ears” are trademarks or a registered trademark of
AcousticSheep LLC. Unauthorized duplication is a violation of applicable law. US Patent No. 8,213,670
and 9,924,271. Other US and international patents pending.