User manual
18
ACOWA INSTRUMENTS, Industrivej 10, 8305 Samsø - VAT-no: 36562919
–
mail: info@acowa.dk
–
Phone: +45 7221 7979
Settings for VI1-2
Function
Description
VI settings
minimum scaling
Minimum measurement reading value
With 1 decimal. (20 = 2,0)
maximum scaling
Maximum measurement reading value
With 1 decimal. (20 = 2,0)
Middling in seconds
middling of the measurement reading value
High limit in use
Activates high limit functions
0=disabled, 1=activated
High limit label
Naming the high limit value
Used in alarm list and SMS
High limit Set point
Defines high limit value
High limit delay in secs.
Signal delay
Stated in seconds
High limit alarm call
Activates alarm signal
0=Local signal, 1=alarm signal
High alarm limit in use
Activates high Alarm limit functions
0=disabled, 1=activated
High alarm limit label
Naming the high limit alarm
Used in alarm list and SMS
High alarm limit Set point
Defines high limit alarm value
High alarm limit delay in secs.
signal delay
0=Local signal, 1=alarm signal
High alarm limit alarm call
Activates alarm signal
0=Local signal, 1=alarm signal
Low limit in use
Activates low limit functions
0=disabled, 1=activated
Low limit label
Naming the low limit value
Used in alarm list and SMS
Low limit Set point
Defines low limit value
Low limit delay in secs.
Signal delay
Stated in seconds
Low limit alarm call
Activates alarm signal
0=Local signal, 1=alarm signal
Low alarm limit in use
Activates low limit alarm functions
0=disabled, 1=activated
Low alarm limit label
Naming the low limit alarm value
Used in alarm list and SMS
Low alarm limit Set point
Defines low limit alarm value
Low alarm limit delay in secs.
Signal delay
Stated in seconds
Low alarm limit alarm call
Activates low limit alarm signal
0=Local signal, 1=alarm signal
The following functions for DI-2 can be selected:
Standard DI function:
Can be used to check the state of a desired digital signal.
Standard VI function (0-10V):
Can be scaled, the scaled value can be displayed. High/low limits are
attached to the signal, which can trigger an alarm if the limits are exceeded.
The following functions for D3-4 can be selected:
Standard DI function:
Can be used to count pulses or check the state of a desired digital signal.
DI3 is further used for the function event signal (event log) for the use of e.g. a level switch. If an alarm is
desired, the "Alarm signal" option is ticked.
Summary of Contents for GEKKO
Page 1: ...User manual GEKKO ...
