17
TROUBLESHOOTING
A layer of frost
occurs in the
compartment
This model of refrigerator is cyclic and not frost free. Because
of this it is normal for ice/moisture beads to form on the back
wall of this unit.
Check the door seal is still sealing correctly, place a torch in to
see if there is any light you can see.
Temperature
inside is too
warm
•
You may have left the doors open too long or too frequently;
•
Is the door being kept open by some obstacle;
•
Large amounts of food has recently been stored with the
appliance.
•
Does the temperature need to be adjusted to a cooler
setting.
Doors will not
close easily
Check whether the top of the appliance is tilted back by 10-
15mm to allow the doors to self-close, or if something inside is
preventing the doors from closing. Are the seals pushed into
the grooves properly.
Units is too hard
to open
This happens because a slight and temporary vacuum occurs
when warm air is let into the appliance when the door is
opened. Wait 30 seconds or use your fingertips to press on
the seal to help ease the vacuum.
Water drips on
the floor
Has the drain hole been cleared, refer to cleaning and care
section of the manual.
The light is not
working
The LED light may be damaged, refer to replacing the LED
lights in cleaning and care section of this manual.
The control system has disabled the lights due to the door
being kept open too long, close and reopen the door to
reactivate this.
