__________________________________________________________________________________
__________________________________________________________________________________
5
Installing your new Appliance
Before using the appliance for the first time,
it is important that you read the below.
Ventilation and Setup of the Appliance
In order to improve efficiency of the cooling
system and save energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat. For this
reason, sufficient clear space should be
available around the appliance.
It is advisable for there to be at least 75mm
of space from the back of the wall, at least
100mm from its top, and at least 100mm
from its side to the wall and a clear space in
front to allow the doors to open 135°. As
shown below
Note:
•
This appliance performs well within the
climate class from
N to T
showed in the
table below.
It may not work properly if being left at a
temperature above or below the indicated
range for a long period of time.
•
Once installed as per the above, allow the
appliance to sit for
two hours
to allow the
gas to settle before turning the appliance
on.
•
Before loading the appliance with food,
ensure it has reached the correct set
temperature. Check inside to see if the
unit is cooler.
•
Stand your appliance in a dry place to
avoid moisture.
•
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away
from any heat sources such as stoves, fires
or heaters.
•
Do not place on carpet.
Levelling of the Appliance
•
For sufficient levelling and air circulation in
the lower rear section of the appliance,
the bottom feet may need to be adjusted.
You can adjust them manually by hand or
by using a suitable spanner.
•
To allow the door to self-close, tilt the top
backwards by about 10mm.
Adjusting the door handle
Before use, please check the appliances
handle. If the handle is loose, please adjust
them by using an Allen key in the clockwise
direction until the handle is secure. The
handle is fitted with two screws that may
need to be tightened from time to time.
