16
17
Mains electrical power is not required as this system runs on batteries only.
Battery information:
Handset - 1 x 9V block
Receiver - 4 x 1.5V AA
To Turn OFF Gas to Stove
•
Turn Knob A clockwise until reaching stop. In this position only pilot gas flows. To shut
off the valve completely, press down slightly and continue to turn clockwise from pilot
position to the OFF position.
•
The safety interlock prevents re-ignition of the pilot flame until the thermocouple has
cooled down sufficiently (elapsed time will vary based on thermocouple type). Switch-
ing off the remote is not necessary.
Handset Operation
Handset Operation
Handset Operation
Handset Operation (refer to Fig. 11)
Setting the Display
•
After connecting the battery or by simultaneously pressing AUTO
AUTO
AUTO
AUTO and TIMER
TIMER
TIMER
TIMER, the dis-
play flashes. You are in set mode.
•
From set mode, press AUTO
AUTO
AUTO
AUTO to switch from
°
F (and 12-hour clock) to
°
C (and 24 hour
clock) or vice versa.
•
The display will automatically return to manual after some time, but you may immedi-
ately return to manual by pressing the TIMER
TIMER
TIMER
TIMER button.
Setting the Current Time
•
After connecting the battery or by simultaneously pressing AUTO
AUTO
AUTO
AUTO and TIMER
TIMER
TIMER
TIMER, the dis-
play flashes. You are in set mode.
•
From set mode press (
) to set hour and (
) to set minute.
•
Wait or press TIMER
TIMER
TIMER
TIMER to return to MANUAL
MANUAL
MANUAL
MANUAL mode.
Programming the Desired Set Temperature
•
Press AUTO until the display flashes.
•
Press (
) or (
) to set the desired temperature.
•
Wait or press AUTO
AUTO
AUTO
AUTO to switch to automatic
mode.
•
A sensor in the transmitter measures the
room temperature. The controller compares
the room temperature with the set temperature
and sends a signal to the receiver to turn
the gas valve motor, which adjusts the flame
height accordingly.
Fig. 11 - Remote Transmitter
REMOTE CONTROLLED STOVES
This stove has a pilot that must be lit manually. When lighting the pilot, follow these
instructions exactly.
Lighting Instructions
Lighting Instructions
Lighting Instructions
Lighting Instructions (refer to Fig. 10)
Lighting the Pilot
1. Turn Knob A (Fig. 10) anti-clockwise towards the ignition position (IGN
IGN
IGN
IGN) until reaching
stop, press down and hold for five seconds (only pilot gas flows).
2. Continue pressing down Knob A while turning further anti-clockwise to activate piezo,
continue to hold down for 10 seconds after pilot burner has been lit. If pilot does
not light, steps 1 and 2 can be repeated immediately.
3. Upon lighting, release knob and turn further anti-clockwise to ON
ON
ON
ON position. Pilot gas
flows and main gas flows in accordance to the temperature setting Knob B.
Fig. 10 - Remote Controlled Valve.
Adjusting the Flame Height
•
To turn the fire on and/or to increase flame height, press ON
ON
ON
ON button of the remote
handset. Continue pressing until the desired flame height is obtained. Press and
hold the OFF
OFF
OFF
OFF button to reverse the procedure.
•
The receiver is equipped with a built-in delay, recognisable by the flickering light, to
facilitate fine adjustment of the flame.
•
The motorised valve is equipped with a slip clutch, allowing manual adjustment of
main gas by turning Knob B.
•
Set the desired programme and temperature on the handset as described in the
Handset Operation section (page 17).
Knob A cannot be turned from ‘PILOT’ to ‘OFF’ unless it is pushed in slightly.
Do not force.
