Page 20
AB-G200L-REM-I01-150914
Subsequent hand set pairing
Display handset
The handset should be supplied already paired with your fire, however if it becomes
necessary to cancel the pairing and re pair it again do the following steps below. (NOTE:
A new pairing can be accidentally started by accidentally pressing the plus and minus
buttons together at the same time on the Control unit and held for 5 seconds.
Factory Reset of display handset
(To enable handset to be paired again) To reset a handset
to factory conditions to enable it to be paired with a
control.
Hold the handset to unlock. Press and hold set
until handset beeps and release the set button.
PROG will be at the top left corner.
Press and release the mode button until the word
SETUP is flashing in the top right corner.
Press and release SET to enter the SETUP menu.
Press and release the set button around 9 times
until you see CA0 on the display.
Press then release the + (or – button) to change
the display to CA1 and press and release the SET
button again.
The word TESC will appear in the window to show
that this handset is now reset and ready to pair
again.
The handset is paired originally in the factory follow instructions over
leaf only if handset is unpaired or replaced
Summary of Contents for BLOOMSBURY
Page 24: ...Page 24 AB G200L REM I01 150914 ...
Page 25: ...Page 25 AB G200L REM I01 150914 ...