Y1-03-0241-2D
17
Figure 5 - Belt Clip
APPENDIX A - ACCESSORIES
1. Multi-Function Belt Clip
The
SARLink™ comes standard with a multi-
function belt clip. To install the clip, simply align
the bottom tabs on the clip with the insert holes
located on the bottom of the beacon. Snap the
clip in place by pressing the top of the clip so
that the two top tabs engage in the two insert
holes on the top of the beacon (see Figure 5). To
remove the clip, push up and back on the top
tabs one at a time to disengage the clip from the
beacon.
The
belt
clip
has
been
designed
to
accommodate your extreme adventures.
You can secure your beacon directly to
backpack webbing straps, life jackets or belts to ensure the beacon is
close at hand. ACR recommends that you secure your beacon
someplace on your person that is easily accessible in case of an
emergency for rapid activation. Ensure the beacon is secured firmly and
is protected before heading out to avoid damage or loss.
NOTE:
ACR recommends that once you have clipped your beacon
in place that you also anchor the beacon with the lanyard to your life
jacket, backpack, etc. to ensure the unit will not be lost if it should
break out of the clip.
