13
Follow Rest
The traveling follow rest (F, Fig.12) is mounted on
the saddle and follows the movement of the turn tool.
Only two fingers are required as the place of the third
is taken by the turning tool. The follow rest is used
for turning operations on long, slender workpieces. It
prevents flexing of the workpiece from the pressure
of the cutting tool.
The sliding fingers are set similar to the steady rest,
free of play, but not binding. Always lubricate with
Mobil DTE®
Oil Heavy Medium.
Controls
1.
Control Panel
– Located on front of gearbox.
A.
Coolant on-off Switch
(A, Fig13) – turns
coolant pump on and off.
B.
Power Indicator light
(B, Fig.13) – lit
whenever lathe has power.
C.
Emergency Stop Switch
(C, Fig.13) –
depress to stop all machine functions.
Caution:
lathe will still have power.
Twist to re-set.
D.
Jog switch
(D, Fig.13) – depress and
release to advance spindle momentarily.
2.
Headstock Gear Change Levers
(E,
Fig.13) – located on front of the headstock.
Move levers according to speed chart for
desired setting.
3.
Leadscrew/Feed Rod Directional lever
(F, Fig.13) – located on front of headstock.
Moving the lever up causes carriage travel
toward the tailstock. Moving the lever down
causes carriage travel toward the headstock.
When chuck is spinning in the forward or
counter-clockwise direction.
Do not
move lever
while machine is running.
4.
Feed/Lead Selector Lever
(G, Fig.13) –
located on the front of the headstock. Used
whenever setting up for threading or feeding.
Caution
:
in the ―A
‖
position, never run the
lathe higher than 650 RAM.
Fig.12
Fig.13
Summary of Contents for 1440GWI
