15
15.
Tool Post Clamping Lever
(J, Fig.14) –
located on top of the tool post. Rotate
counter-clockwise to loosen and clockwise to
tighten.
16.
Tailstock Quill Clamping Lever
(
A,
Fig.15) – located on the tailstock. Lift up to lock the
spindle. Push down to unlock.
17.
Tailstock Clamping Lever
(B, Fig.15) –
located on the tailstock. Lift up lever to lock. Push
down lever to unlock.
18.
Tailstock Quill Traverse Handwheel
(C,
Fig.15) – located on the tailstock. Rotate clockwise
to advance the quill. Rotate counter-clockwise to
retract the quill.
19.
Tailstock Off-Set Adjustment
(D, Fig.15)
– two hex socket cap screws located on the tailstock
base are used to off-set the tailstock for cutting
tapers. Loosening one screw while tightening the
other off sets the tailstock.
20.
Foot Brake
(A, Fig.16) – located between
stand pedestals. Depress to stoop all lathe functions.
21.
Micro Carriage Stop
(B, Fig.16) – located
on the lathe bed. Loosen two hex socket cap screws
underneath body and slide along bed to desired
position. Tighten screws to hold in place.
22.
Main Power Switch
(not shown) – located
on the electrical box door on the rear of the lathe.
Turns main power to the lathe on and off.
Break-In Procedure
During manufacture and testing, this lathe has been
operated in the low R.P.M. range for three hours.
To allow time for the gears and bearings to break-in
and run smoothly, do not run the lathe above 650
R.P.M. for the first six hours of operation and use.
Fig.15
Fig.16
Summary of Contents for 1440GWI
