第 6 页
Internet of Things modules and specifications of the electrical
box, and install the modules in combination according to the
sequence shown in the picture. Each module is connected with
the manufacturer's special 8-pin data cable.
3) The circuit breaker should be installed vertically. When the
handle is in the "/OFF" state, the contact is disconnected.
When the handle moves upward, the contact moves in the closed
direction.
4) The nominal cross-sectional area of copper wire matching the
rated current of circuit breaker is shown in Table 5.
Table 5
Rated Current
(A)
10
1 6~ 2 0
25
32
4 0 ~ 5 0
63
Cable (mm²)
1.5
2.5
4
6
10
16
Torque (N.m)
3.5
3.5
3.5
3.5
3.5
3.5
5) During installation, please tighten the copper wire with the
torque specified in Table 5. After installation, check whether
the copper wire is connected by shaking the wire
Firm, and tighten the copper wire again with the specified
torque.
Wiring
4.3.
Wiring diagram
Summary of Contents for ASCB1 Series
Page 10: ...第 6 页 Maximun number 18 ...
