INDUSTRIAL I/O PACK SERIES APCe8650
PCI BUS CARRIER BOARD
Acromag, Inc. Tel: 248-295-0310
- 25 -
www.acromag.com
An email question can also be submitted from within the Knowledge Base or
directly from the “Contact Us” tab.
Acromag’s application engineers can also be contacted directly for technical
assistance via telephone or FAX through the numbers listed below. When
needed, complete repair services are also available.
Phone: 248-624-1541
Fax: 248-624-9234
Email:
6.
SPECIFICATIONS
PHYSICAL
Physical Configuration
Length (APCe8650) ........................ 12.283 inches (312.0 mm)
Height ............................................. 4.200 inches (106.68 mm)
Board thickness .............................. 0.063 inches (1.60 mm)
Max component height ................. 0.380 inches (9.65 mm)
Max component height under IP modules
0.180 inches (4.57 mm)
Connectors
P1 (PCIe Bus) .................................. PCI Express V1.1 x1 lane
A-D (Carrier Field I/O) .................... 50-pin Low Profile Male Header (TE P/N 1-1761685-5).
P2, 5, 8, 11 (IP Field I/O) ................ 50-pin male plug header
P4, 7, 10, 13 (IP Logic) .................... 50-pin male plug header (AMP 173280-3 or equivalent).
Power
Board power requirements are a function of the installed IP modules. This specification lists currents for the
carrier board only. The carrier board pr5V, +12V and -12V power to each IP module. Power for the
IP modules can be supplied either from the PCIe bus +12V supply or from the auxiliary peripheral power
connector or the PCIe graphics power connector. The +12V power source for the IP modules is selected by
jumper J1. The APCe8650 contains DC/DC converters, which generate the +5V and -12V supplies from the
se12V source. Each IP module supply line is individually filtered and fused. In addition the carrier
board utilizes PCIe bus 3.3 volt power for logic. Note that the maximum amount of current provided to the
carrier card via the PCIe bus varies with each system. Refer to your system documentation for more
information on PCIe power specifications.
Fuses
+5 volts, 2 amps (minimum) per slot
12 volts, 1 amp (minimum) per slot
The power failure monitor circuit provides a reset to IP modules when the 5 volt power drops below 4.5 volts
typically / 4.37 volts minimum.
