INDUSTRIAL I/O PACK SERIES APCe8650
PCI BUS CARRIER BOARD
Acromag, Inc. Tel: 248-295-0310
- 26 -
www.acromag.com
Currents specified are for the carrier board only for Model APCe8650(E), add the IP module currents for the
total current required from each supply.
+3.3 Volts (
10%) ........................... 190 mA Typical
220 mA Maximum
+12 Volts (
5%) .............................. 130 mA Typical
150 mA Maximum
PCIe BUS COMPLIANCE
Specification ................................... This device meets or exceeds all written PCI Express specifications per revision
1.1 dated March 28, 2005.
Data Transfer Bus ........................... Slave with 32-bit, 16-bit, and 8-bit data transfer operation. 32-bit read or
write accesses are implemented as two 16 bit transfers to the IP modules.
INDUSTRIAL I/O PACK COMPLIANCE
Specification ................................... This device meets or exceeds all written Industrial I/O Pack specifications per
ANSI/VITA 4 1995 for 8MHz and 32MHz operation with a maximum of four IP
modules. Supports Type I and Type II ID space formats.
Mechanical Interface ..................... Carrier supports four single-(For APCe8650) size IP modules.
Electrical Interface ......................... Carrier drivers use 5V CMOS logic
IP Clocks ......................................... Support 8MHZ (default) or 32MHz IP clocks that are independently selected
per each IP slot.
I/O Space ........................................ 16-bit and 8-bit: Supports 128 byte values per IP module.
ID Space ......................................... 16 and 8-bit; Supports Type 1 32 bytes per IP (consecutive odd byte
addresses). Also supports Type II 32 words per IP via D16 data transfers.
Memory Space ............................... 16 and 8-bit: Supports up to 8M bytes per IP.
Interrupts ....................................... PCI bus INTA# interrupt signal
Up to two requests sourced from each IP are mapped to INTA#. Interrupt
vectors come from IP modules via access to IP module INT space. One MSI
interrupt is also supported.
ENVIRONMENTAL
Operating Temperature ................. 0 to +70
C (APCe8650)
-40 to +85
C (APCe8650E)
Relative Humidity........................... 5-95% non-condensing
Storage Temperature ..................... -55 to +125
C.
Non-Isolated .................................. The PCIe bus and the IP module commons have a direct electrical connection.
As such unless the IP module provides isolation between the logic and field
side, the field I/O signals are not isolated from the PCIe bus.
Radiated Field Immunity ................ Designed to comply with IEC61000-4-3: 2006 Level A (10V/m, 80 to 1000MHz
80% AM modulation, 1 KHz).
Surge Immunity .............................. Not required for signal I/O per European Norm EN61000-6-1.
Electric Fast Transient Immunity
Designed to comply with IEC61000-4-4: 2007 Level 3 (1kV at field input and
output terminals, capacitive coupling clamp used)
Radiated Emissions ........................ Designed to comply with CISPR 16-2-3 class A
