INDUSTRIAL I/O PACK SERIES APCe8650
PCI BUS CARRIER BOARD
Acromag, Inc. Tel: 248-295-0310
- 6 -
www.acromag.com
IP Module Selectable Clock
- Allows for each IP module to be individually
configured to an 8MHz or 32MHz clock.
Optional Screw Termination Panel
- Model supports field connection via
screw terminals using the optional DIN rail mount termination panels.
Connectors Access I/O
- Access to field I/O signals is provided via 3M Low
Profile 50-pin headers with cable ejector latches. A separate header is
provided for each IP module.
Supervisory Circuit for Reset Generation
- A microprocessor supervisor circuit
provides power-on, power-off, and low power detection reset signals to the IP
modules per the IP specification.
Individually Filtered Power
- Fi5V, +12V, and -12V DC power is
provided to the IP modules via passive filters present on each supply line
serving each IP. This provides optimum filtering and isolation between the IP
modules and the carrier board and allows analog signals to be accurately
measured or reproduced on IP modules without signal degradation from the
carrier board logic signals.
Individually Fused Power
- Fused +5V, +12V, and -12V DC power is provided.
A fuse is present on each supply line serving each IP module.
PCI Express BUS INTERFACE FEATURES
Slave Module
- All read and write accesses are implemented as either a 32-bit,
16-bit or 8-bit single data transfer.
Interrupt Support
- PCI bus INTA# interrupt request is supported. All IP
module interrupts are mapped to INTA#. Carrier board software
programmable registers are utilized as interrupt request control and status
monitors. One MSI interrupt is also supported.
SIGNAL INTERFACE PRODUCTS
This IP carrier board will mate directly to all industry standard IP modules.
Acromag provides the following interface products (all connections to field
signals are made through the carrier board which passes them to the
individual IP modules):
Cables
Model 5025-551-X (Shielded Cable) or Model 5025-550-X (Non-Shielded
Cable): A Flat 50-pin cable with female connectors at both ends for
connecting carrier boards, to Model 5025-552 termination panels. The
unshielded cable is recommended for digital I/O, while the shielded cable is
recommended for optimum performance with precision analog I/O
applications. The cables are available in 4, 7, or 10 feet lengths. Custom
lengths (12 feet maximum) are available upon request.
Termination Panel:
