Operation Manual, Xymba XB43/53
Version V1.2
22
© 2008, Acronova Technology, Inc.
F
REQUENTLY
A
SKED
Q
UESTIONS
Why is my duplication failure rate so high?
Try a lower writing speed using the software.
Use a different brand of blank discs.
Check the power source.
Why do my discs get stuck in the disc loader during the
duplication process?
Check to see if the disc is the standard size (120mm).
Make sure discs are level in the loader.
Reduce the quantity of discs per load. Some discs may bend
from the weight of the discs placed on top of them.
Use a different brand of blank discs.
Why won’t the power switch work all the time?
Allow a 30 second interval when switching the power on and off.
Why does the disc loader fail to pick up the disc?
Check to see if the disc is the standard size (120mm).
Make sure the discs are not bent or damaged.
Why is the disc unloader dropping two or more discs at a time?
Check to see if the disc is the standard size (120mm).
Make sure the discs are level when inserted.
Separate or loosen the discs from each other before use.
Use the same brand of discs. Do not mix disc types or brands.
Reduce the quantity of discs per load. Some discs may bend
from the weight of the discs placed on top of them.
Use a different brand of blank discs.
How can I restart or reset Xymba when it is not working properly?
Turn the power switch to the Off position and back to the On
position after waiting 30 seconds. If this does not solve the
problem, please contact your dealer or authorized service center.
