W
W
i
i
F
F
i
i
V
V
o
o
I
I
P
P
P
P
h
h
o
o
n
n
e
e
(Press
[S]
button to skip this value)
- SIP Authenticate Password – Administrator will be supported
(Press
[S]
button to skip this value)
- SIP Registration Expire Time – Administrator will be supported
(Default value is 3600 seconds)
6) Select “3.Setup WLAN” menu and configure the WLAN informations
Input the SSID of AP(Access Point), Encryption mode of WiFi, Security configure,
Roaming mode and Connection mode of WLAN in this mode.
- SSID of AP : Scanning Mode and Direct input mode
- Encryption Mode : Configure Static WEP key value of AP when using Encryption mode.
- 802.1x Security : Configure security informations when using Security mode.
- Roaming mode : Select Roaming state of AVP-2000B (Default is disable)
- Connection mode : Select WiFi Connection mode (Default is Infra-structure mode)
7) Select “4.Setup NAT” menu and configure the NAT informations when needed.
(AVP-2000B supports two kind of NAT mode, one is STUN protocol and the other is Static
NAT. Administrator will be support for about this operation.)
- STUN Mode
Administrator can supports STUN server IP address and port value.
Default value of STUN server IP address is same as SIP Registrar Server IP address
and value of STUN port is 3478.
- Static NAT
Some kind of Route Server can not support dynamic allocation of port number. In this
case, select “Static NAT” mode to operate normally.
8) Select “5.Setup CODEC” menu if need to change.
AVP-2000B supports G.711 a/mu – law and G.729ab mode CODEC as default.
9) Press
[ ]
button to save and reboot AVP-2000B
AVP-2000B will reboot and register on SIP Registrar Server.
10
