Flush Mount Unit
Mounting plate is attached to the pattress
using the
screws supplied.
Ensure
the correct spacers have
been used to bridge the gap between the mounting
plate and the fixing wings of the pattress
box to avoid
the mounting plate being distorted.
Place the reader / keypad onto the
surface mount collar and clip
down into place. Use the security
screw supplied to attach the unit
to the flush mount collar.
Security screw
supplied with the unit
Screws
Standard
pattress box
Place the cap onto the unit
and push firmly in place
Note:
Determine the distance between the pattress box
and the mounting plate, using the spacers that are
labelled 1mm to 4mm. A spacer of the correct
length is assembled by stacking the spacers
together.
Spacers break away
from main component
when required by
installer for use
View showing spacer
stacking
View shows mounting
plate before spacers are
broken away by installer
Copyright © 2016 Access Control Technology Ltd. Part No.18-00094 Issue 1.1
ACT 5e prox Operating and Installation Manual
12
Figure 4– Mounting instructions for flush mount unit
ACT 5e prox 2R.indd 13
19/02/2016 17:05:29
