ACT-HDC 112 SH Quick Installation Guide
1. Please read carefully these notes below before copying.
(1) ACT-HDC 112 SH supports all kind of Image Copy such as SCSI HDD copy to
SCSI HDD; SCSI HDD copy to IDE HDD; SCSI HDD copy to SATA HDD;
IDE HDD copy to IDE HDD; IDE HDD copy to SATA HDD, and SATA HDD
copy to SATA HDD.
(2)
ACT-HDC 112 SH only supports one to one copying when you execute the
copy of SCSI HDD to SCSI HDD, SCSI HDD to IDE/SATA HDD, and
IDE/SATA HDD to SCSI HDD.
ACT-HDC 112 SH supports copying one to two when you execute the copy of
IDE HDD to IDE/SATA HDD and SATA HDD to SATA/IDE HDD.
(4) Before putting on your source HDD and target HDD, please confirm the power
is turning off, and then turn on the power to copy. After copying completely, first,
turn off the power, and then take away your HDD from ACT-HDC 112 SH.
(5) Before copying, please check again your source HDD whether is correct, you
can know this information in function 6 Select Source. If your source is SCSI
HDD, please check the SCSI ID, generally, the default is SCSI ID0. If your
source is IDE HDD, please check whether the IDE ID is ID0.
(6) Before copying, please check it again whether the capacity of the target HDD is
equal or more than the target.
(7) When SCSI HDD copy to SCSI HDD, please disable your terminator on the
HD. This parameter only appears on single end (SE) SCSI and does not appear
on LVD SCSI.
(8) Please pay attention that connecting of between adapter and 2.5 inch HDD
when you copy 2.5 inch HDD with adapter, because the pins of 2.5 inch HDD
