22
2.7
J-Arm Mount Installation:
Install the head/helmet mount
adapter into the monocular by following the procedure.
1.
Align the thumbscrew with the threaded hole and tighten
as shown in Figure 2-3.
2.
Locate the alignment boss on the J-Arm mount adapter that
fits into a groove on the monocular.
3.
Make sure the boss on the adapter fits into the groove on the
monocular.
4.
Loosen the clamp knob and pivot the arm to the other side
for THE-14 use with the right eye.
Figure 2-3 J-Arm Mount Adapter Installation
Summary of Contents for THE-14
