6
The Base Station & Air Interface Test Module
(BAT)
The BAT Module is a handheld RF spectrum meter based on
the Acterna TestPad 2000
TM
platform. Base stations can be
tested while in operation, without any shut down. You can test a
base station either at its RF output connector or over the air
interface. Simple use and a small size make testing easier than
ever.
About this manual
The Getting Started Guide supplements the complete operating
manual. It should be read before installing the BAT Module and
taking it into operation. Further instructions are contained in the
operating manual which is included with the BAT Module in the
form of detailed online help.
This booklet will provide you with initial information and guide
you up to the point where you will be able to retrieve more
detailed information from the online help.
The main sections of this manual advise you
• how to unpack and install the BAT Module
• about the main applications
• about the highest menu level of the user interface
• how to retrieve more help from the built-in online help
Safety instructions
Maintenance and repair is only allowed for specially trained ser-
vice technicians. Opening a unit without permission causes loss
of warranty.
See “Service and Calibration” on page 27 and the Federal Com-
munication and Industry Canada Notices on page 28.
