www.acti.com
3
Using NVR 3.0
Only get stream by VMS
Use the following steps:
1. Web Configurator/Setup: Set the camera to MD Preset Mode
2. Web Configurator/Live: Open PTZ window and set Preset Points
3. Web Configurator/Setup: Open Motion Detection page and set MD regions and priorities.
4. Web Configurator/Setup: Add a new user, for example
“user” with password “123456”.
5. NVR/Setup: Add KCM-3911 to VMS
manually
while typing the name
“user” and “123456”
into channel settings. This will prevent VMS from doing unwanted changes in camera
settings because it would require admin access to camera. VMS knows that it is an
“unsupported mode”, but is unable to change it and has to accept the stream under
camera
’s MD Preset mode.
6. NVR/Live: Watch the live view from KCM-3911 running on MD Preset mode
Using Standalone NVR 1.02.12
Only get stream by VMS
Use the following steps:
1. Web Configurator/Setup: Set the camera to MD Preset Mode
2. Web Configurator/Live: Open PTZ window and set Preset Points
3. Web Configurator/Setup: Open Motion Detection page and set MD regions and priorities.
4. Web Configurator/Setup: Add a new user, for example
“user” with password “123456”.
5. NVR/Setup: Add KCM-3911 to VMS
manually
while typing the name
“user” and “123456”
into channel settings. This will prevent VMS from doing unwanted changes in camera
settings because it would require admin access to camera. VMS knows that it is an
“unsupported mode”, but is unable to change it and has to accept the stream under
camera
’s MD Preset mode.
6. NVR/Live: Watch the live view from KCM-3911 running on MD Preset mode
Video Clip
To know more about the practical use of Motion Detection Preset Mode and how to set it up by
NVR to
“get stream only”, please refer to the following video clip in ACTi Video Clip Portal:
