www.acti.com
TCM-5001 Hardware User’s Manual
10
LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for another
second and turn off again. By this time the reset to default operation is already completed.
This will take around 20 seconds from power up.
You may then release the reset button.
This length of time fluctuates slightly with the environment. The Power LED light will come
back on and stay on after a few more seconds. The unit will start up with factory default
settings automatically.
On (3s)
On
1s
Power On
About 20 Seconds
Stay On
Off (about 15s)
Off (10~15s)
Restore to Default
Complete
3) Audio Input / Output
The IP device supports audio input and output with earphone jack
4) Digital Input / Output
Used in applications like motion detection, event triggering, time lapse recording, alarm
notifications, etc., the I/O terminal connector provides the interface to:
•
1 transistor output
- For connecting external devices such as relays and LEDs. Connected
devices can be activated by Output buttons on the Live View page or through video
management software.
•
1 Digital Input
- An alarm input for connecting devices that can toggle between an open and
closed circuit, for example: PIRs, door/window contacts, glass break detectors, etc. The device
will detect the change in digital input and transmit the signal to video surveillance servers.
•Auxiliary power and GND
Pin 1
GND
Ground
Description
Pin 2
Auxiliary DC
Power input
(not to power
this camera)
Electrically connected in parallel with the con-
nector for the power supply, this pin provides
an auxiliary connector for mains power to the
unit.
This pin can also be used to power auxiliary
equipment, with a maximum current of
Voltage: 12V DC,
Max: 1.2W
