© Action Drone, Inc. All Rights Reserved.
|
AD2 User Manual V1-052316
21
< BACK TO CONTENTS
< BACK TO CONTENTS
Preflight Checklist
Flight Checklist
Take-Off Sequence
Joystick control
Landing Sequence
FLIGHT OPERATIONS
PREFLIGHT CHECKLIST
In order to ensure a safe and smooth flight, always perform the following Preflight Checklist before flying.
Calibrate compass, auto take-off/landing, arm/disarm motors, test.
Ground Station
Laptop …
Power On
Laptop Battery…
Confirm Battery Lifespan
Mission Planner …
Start
Telemetry Module …
Connect USB
Telemetry Module Antenna …
Orient vertically
Com Settings …
Com Port Select, Baud 57600
Aircraft
Frame …
Open & lock arms (ensure all screws secured)
Propellers …
Secure (disc on top of prop), Undamaged, Correct Direction
Motors…
Secured, undamaged
ESCs …
Secured, undamaged
GPC Receiver & Cable …
Secured
RC Rx & Connections …
Secured
Telemetry Module & Cable …
Secured
Flight Controller & Connections … Secured
Battery Charge …
Confirm fully charged
Battery Straps …
Secure (do not plug into AD2 yet)
Radio
Battery Charge …
Confirm fully charged
Knobs, switches, and sticks …
Inspect for full range of motion
Antenna …
Orient horizontally
Timer …
Confirm functions
Camera Sensors
Battery …
Confirm fully charged
Memory card …
Confirm sufficient space for recording footage
Gimbal …
Secured to camera
FPV Equipment
Battery …
Confirm fully charged
Antennas …
Fastened
Channel …
Tune FPV equipment to the same channel
FPV Connections …
Secured into onboard camera(s)
Figure 3.3: AD2 in Travel Position