Action Sports Equipment S001021 Assembly, Installation, Care, Maintenance, And Use Instructions Download

Page: 3 / 8

ACTION SPORTS EQUIPMENT PTY LIMITED –

www.actionsports.com.au

Page

Section 1 – Skirting Assembly

1.1

Lay out the Skirting on a clear, dry level

surface as shown in Figure 1.

Figure 1

1.2

Secure one end of the skirting to the Lower pole tube as shown in Figures 2 & 3.

1.3

There are four pre-sewn loops and four tying straps with carabiner clips at the top of the

skirting, each is in line to the enclosure with carabiner clip to each loop by going over

the lowest hook and loop tape. See Figures 4 & 5. Secure the other end of the skirting

to the Lower pole as Figure 6.

Summary of Contents for S001021

Page 3: ...1 1 2 Secure one end of the skirting to the Lower pole tube as shown in Figures 2 3 1 3 There are four pre sewn loops and four tying straps with carabiner clips at the top of the skirting each is in line to the enclosure with carabiner clip to each loop by going over the lowest hook and loop tape See Figures 4 5 Secure the other end of the skirting to the Lower pole as Figure 6 ...

Page 4: ...kirting to the Trampoline See Figure 7 Pull the bottom of the skirting down to the trampoline using the elastic straps going around the Trampoline top rail tube and attach them to the nearest V ring of the trampoline mat beneath the safety pads as shown in Figures 8 9 1 5 When the assembly of the skirting is completed it will be shown as figure 10 Figure 10 ...

Page 5: ...on 2 Door Panel Assembly 2 1 Layout the Door Panel on a clear dry level surface as shown in Figure 11 Figure 11 2 2 Secure the Door Panel to the two Pole Tubes next to the net entrance as shown in Figures 12 13 2 3 Repeat step 2 2 Secure all fixing points shown in Figure 14 ...

Page 6: ... the bottom of the Door Panel Pull the elastic straps down to the trampoline and hook them to the nearest V ring of the trampoline mat as shown in Figure 15 2 5 When the trampoline is to be used the Door Panel can be rolled up as shown in Figure 16 The assembly of the trampoline trim kit is now completed ...