13
S002035-3 Verao 427cm (14ft) Trampoline
Assembly Instructions (cont)
Step 3
Lay the Mat (1) out flat on the floor inside of the completed trampoline frame. Ensure that the side of
the Mat (1) with double stitching is facing downward, the warning label stitched into the mat should be
located on the top side of the mat.
PLEASE NOTE
: This image shows a four leg trampoline and is for reference only. The trampoline that
you have received has 6 legs.
1
To begin attaching the Mat (1) to the frame take 2 x Springs (6) and place these at opposite ends of the
Mat (1). Place the end of a Spring (6) with the narrow opening over the metal v-rings at the edge of the
mat and insert the opposite end of the Spring (6) with the wide opening into the groove on the Top Rail
(3). Repeat this for the other Spring (6) to even out the tension in the mat.
Wide opening
Narrow opening
Take another 2 x Springs (6) and repeat the above instructions using the Spring Hook (8) so there are now
4 x Springs (6) connecting the Mat (1) to the Top Rails (3) at points ¼ the way around the frame. Use the
remaining Springs (6) to connect the Mat (1) to the Top Rails (3) securing it into position.
NOTE: It is recommended that you connect a handful of springs on one side of the frame and then connect the
same number of springs to the opposite side of the frame, this will even out the tension on the springs from
the mat and make it easier to connect the last couple of springs.
6
8
