18
S002035-3 Verao 427cm (14ft) Trampoline
Assembly Instructions (cont)
Step 8
Locate the zipper on the Net (13) and align this to face the where you would like the entrance of the
trampoline to be. Lift the Fibreglass Rod (14) ring and connect it to the enclosure pole caps by inserting it
into the grooves.
NOTE:
Ensure that it is the black part of the fibreglass rods that is connected to the caps on the
enclosure pole and not the metal rod connectors, you may damage the pole caps if you try and force
the metal connectors into the grooves.
To secure the Net (13) to the frame of the trampoline, take the clips located at the bottom of the Net (13)
near each enclosure pole and pull these down over the top of the Frame Pad (2) and underneath the Top
Rails (3). Connect the right clip to the v-ring of the spring to the left and connect the left clip to the v-ring
of the spring to the right, making an “X” shape.
WARNING: Do not position your face close to the strap as if you let go it can rebound at high speed causing
injury.
Repeat this instruction for the remaining clips at each enclosure pole. There will be a few remaining clips
along the Net (13) in between each enclosure pole, pull these clips down over the Frame Pad (2) and
underneath the Top Rails (3). Connect these to the closest v-ring to finish securing the Net (13) to the
trampoline frame.
Finish attaching the Net (13) to the trampoline by taking the hook and loop tape located on the Net (13)
and securing it around each enclosure pole.
Attach 1 x Safety Instruction Placard (7) to an enclosure pole in a position next to the entrance of the
trampoline that is easily visible. Thread the included cable tie through the hole in the Safety Instruction
Placard (7) and wrap it around the enclosure pole.
