AFTER SALES SUPPORT
1800 465 070
10
service@actionspares.com.au
MODEL: S002145
Assembly Instructions (cont)
12. Insert the Pedal Axle (58) into the welded tube on the Frame (39) and center it.
Place a Pedal Spacer (32) and an M13x22mm Washer (33) onto each side of the
Pedal Axle (58).
Slide the Right Pedal (30) onto the right side of the Pedal Axle (58), and slide
the Left Pedal (57) onto the left side of the Pedal Axle (58). Secure the pedals
into place using an M8x20mm Washer (16), an M8 Split Washer (15) and an M8
Acorn Nut (31) on each side of the Pedal Axle (58).
13. Insert a Pedal Strap (29) through the Right Pedal (30) and wrap the end of the
Pedal Strap (29) through the buckle on the Pedal Strap. Repeat this for the Left
Pedal (57).
14. Attach the 2 x Foot Plates (52) to the Front Stabiliser (50) using 2 x Foot Plate
Pins (51).
15.Carefully pry the Console (66) out of the Shields (44, 69).
NOTE:
Be careful not to pull on the wire attached to the Console.
Remove the screw and the battery cover from the back of the console. Insert
batteries into the battery compartment. Reattach the battery cover and secure into
place with the screw and press the Console (66) into the Shields (44, 69).
NOTE: The console requires 2 x AA batteries (included).
WARNING: Batteries must be inserted according to the correct polarisation (+ and -). If the rowing machine is not
going to be used for a long period of time, we recommend the batteries are removed.
WARNING: To prevent battery leakage;
• Be sure to insert batteries correctly and always follow the battery manufacturer’s instructions.
• Never mix alkaline, standard or rechargeable batteries.
• Use only batteries of the same or equivalent type as recommended.
• Always remove exhausted or dead batteries from the product and do not dispose of batteries in fire, batteries
may explode or leak.
• Do not short circuit the supply terminals.
33
32
15
39
16
30
31
31
57
58
57
30
29
29
52
50
51
