42
Actiontec 54 Mbps Wireless DSL Gateway User Manual
43
Chapter 4
Using Advanced Setup
LAN IP Address
Selecting
LAN IP Address
in the “Configuring the Advanced Settings” screen gen-
erates the “
LAN IP
Address” screen.
The values in the
“Device IP
Address” and “Device
LAN
Netmask” text boxes are the
IP
address and Subnet mask of the Gateway as seen on the network. These values
can be modified for your
LAN
network, but Actiontec recommends keeping the
default factory settings (
IP
address 192.168.0.1 Subnet mask 255.255.255.0).
☞
Note
: If the Gateway’s
LAN IP
Address is modified, ensure the
DHCP
Server range is within the same subnet. For more infor-
mation, see “
DHCP
Server Configuration.”
After changing settings, click Next or Back to continue, or Save and Restart to
make all changes permanent.
DHCP Server
Selecting
DHCP
Server
in the “Configuring the Advanced Settings” screen gener-
ates the “
DHCP
Server” screen. The Gateway has a built-in
DHCP
(Dynamic Host
Configuration Protocol) server that automatically assigns a different
IP
address to
each computer on the network, eliminating
IP
address conflicts.
The factory default setting is
On
. To disable the
DHCP
Server, select
Off
.
Summary of Contents for GT704-WG
