NMEA Data Multiplexer - NDC-4
Page 11
© 2015 Active Research Limited
4.
Click the
‘Browse’
button and locate the folder that the
USB driver is saved (containing “
ftdibus.inf”
). Once
the folder is selected click
‘Next’
.
5.
When the
‘USB Serial Converter’
driver has completed
the
‘Virtual Serial Port’
driver will need to be installed in
the same way. This time in
‘Device Manager’
right click
‘USB Serial Port’
and select
‘Update Driver Software’
.
6.
Repeat steps 3 and 4 to install the
‘Virtual Serial Port’
driver.
Now both drivers are installed see
for details on how to find out which COM port
number has been allocated to your
Actisense
device as
well as how to change to a different COM port.
Windows XP and Windows NT/2000
The following instructions are for Windows XP. Although
not the same, Windows NT/2000 users will be able to use
this information as well.
1.
Connect the USB cable and Windows will automatically
open the
‘Found New Hardware Wizard’
. If an active
Internet connection is available select
‘Yes, this time
only’
, click
‘Next’
and go to step 4. Without an active
Internet connection select
‘No, not at this time’
and click
‘next’.
2.
If using drivers from the CD, choose
‘Install the
software automatically (Recommended)’
and click
‘next’
. Windows will search the CD and install the drivers,
go to step 4. If using drivers downloaded from the
Actisense
website, choose
‘Install from a list or specific
location (Advanced)’
and click
‘Next’
.
Summary of Contents for NDC-4
Page 2: ......
