Page 20
© 2015 Active Research Limited
Company Information
Active Research Limited
5, Wessex Trade Centre
Ringwood Road
Poole
Dorset
UK
BH12 3PF
Telephone:
01202 746682 (International : +44 1202 746682)
Actisense
on the Web: For advice, support and product details
E-mail:
Website:
Twitter:
www.twitter.com/ActisenseNews
(
Actisense
News and Product Updates)
www.twitter.com/ActisenseTech
(
Actisense
Product Updates)
Facebook:
bit.ly/actibook
(
Actisense
News and Product Updates)
LinkedIn:
linkd.in/actisense
(
Actisense
News and Product Updates)
“Actisense” is a registered trademark of Active Research Limited.
Order Codes
NDC-4
5 isolated inputs (4 NMEA HS), 2 ISO-Drive outputs
NDC-4-USB
4 isolated inputs (3 NMEA HS), USB In & Out and 2 ISO-Drive outputs
NDC-4-AIS
NDC-4 base unit pre-configured for AIS
NDC-4-AIS-USB
NDC-4-USB unit pre-configured for AIS
NDC-4-ASW
NDC-4 base unit pre-configured as an Autoswitch
Returns Procedure
Actisense
prides itself on having a very low product return rate. In the unlikely event that you need to return a unit for
repair, it is important to follow these steps.
1.
Download and install the latest Firmware version and Control Centre software from
.
2.
Read through the “Troubleshooting Guide” on page 20 of the “Full user manual” available on the CD and from
to see if your problem has a simple solution.
3.
Contact
Actisense Tech Support
at the email address below for further support and an
RMA number
.
To qualify for an
RMA number
you will need to provide the serial number, date of purchase and where you purchased
the unit from. You will be asked to confirm the above steps have been attempted and the nature of the fault.
Any units returned without an
RMA number
will incur a delay in processing and may result in a charge dependant on
the guarantee status of the unit.
Summary of Contents for NDC-4
Page 2: ......
