6
Remote Operated Multi-Colour Chromotherapy LED Lighting System
1 x Remote control.
1 x Remote control holder.
1 x Infa red sensor.
1 x Chrome casing for above.
1 x Multicolour LED light.
1 x Electronic control box including dry running protection sensor
1 x Connection lead - 2 metres
Operating voltage 220/230 volt - 50/60 hertz.
The system should be protected by a 6 AMP RCD with 30 -32 MA Sensitivity.
The LED is transformed down to 12 volt and has a power rating of 12 watt.
A separate means of Isolation should be provided for future maintenance.
The water level must be above the light fitting before the lighting system is activated.
The system incorporates a sensor to protect it from damage that will turn the light off if the
water level is not at the correct depth.
Connect the light to a circuit breaker, then to the power supply and operate by the remote
control
Single Clear Manually Operated LED Light
Connect the factory fitted underwater light to a circuit breaker and then to the power supply.
A remote switch such as a pull cord should be used to operate the light.
The power is transformed to 12 volts and LED light is 5 Watts. The light should be switched off
when the pool is empty.
Trouble Shooting LED Lights
The lights are tested at the factory prior to delivery.
Occasionally the fitting becomes loose during shipment and installation preventing the unit
from functioning.
If the light is not operational please follow these instructions:
