5
6. Center openings and press
mounting plate onto duct. The
adhesive gasket will hold the
mounting plate in place.
8. Insert unit into opening.
Be sure the air will pass
though the ActivePure
®
Cell honeycomb matrix.
9. Secure the unit to the
mounting plate with (4) thumb
nuts.
7. Secure the mounting plate using
(8) #8 self-tapping screws.
NOTE:
Unit requires continuous power. Do not install where power to the unit will be cycled on and off.
1. Locate suitable
area of duct for
installation.
3. Mark location for 3.5”
opening using the
mounting plate.
4. Cut hole in duct
using 3.5” hole saw.
2. Cut away insulation
to expose metal
duct (if needed).
1/4
a. Using the mounting plate,
mark 4 Cutting Method
holes on duct.
b. Drill 4 holes where marked.
c. Cut between holes
using tin snips.
ALTERNATE CUTTING METHOD
METAL DUCTWORK INSTALLATION
5. Remove backing from
mounting plate adhesive
gasket.
Power Connection Requirements:
This device is designed to operate using
a 24 VAC, 40Va transformer. Transformers supplied with a straight cooling
or HVAC system may be used to power the device but must be verified it’s
capable of handling the additional device load before installation. If the system
transformer is not capable of handing the extra load, a separate 24 VAC, 40Va
transformer MUST be used. Do not connect the device to any power source
with a voltage less than 22 VAC and a maximum of 32 VAC. Doing so will cause
damage to the device.
WARNING
