8
Your ActivePure
®
Induct Guardian I unit requires no periodic
maintenance beyond normal replacement of the ActivePure
®
Cell
every one (1) year.
The UV lamp operation indicator on the face of the unit will glow
when the UV lamp is in use. If the indicator does not glow and
the unit has power, the ActivePure
®
Cell should be replaced.
Power
Cord
UV Lamp Operation Indicator
2. Remove the 4
thumb nuts.
3. Remove the unit from
the mounting plate.
4. Remove the 2 thumb
screws holding the
ActivePure
®
Cell.
5. Remove the used ActivePure
®
Cell from the base unit and
dispose of the bulb properly.
6. Plug the new ActivePure
®
Cell into the base unit. Be
sure Air Flow / Honeycomb
Cell direction is correct.
7. Secure with 2
thumb screws.
8. Insert the unit into the
mounting plate.
9. Secure unit with 4
thumb nuts.
10. Reconnect
power cord.
MAINTENANCE/UV LAMP INDICATOR
CHANGING THE ACTIVEPURE
®
CELL
1. Disconnect (unplug) power
cord from unit
NOTE:
Always follow OHSA electrical lockout safety requirements to prevent accidental release of energy
during service or maintenance activities.
NOTE:
Visit: www.lamprecycle.org
for proper bulb disposal regulations.
• UV Light in operation; disconnect unit from power cord before servicing; failure
to follow warnings may result in severe eye damage
• Disconnect power at the breaker or fuse panel before servicing unit;
always follow OSHA lockout procedures to prevent accidental exposure to
electrical energy
WARNING
