Installation and Commissioning Guide
Split Ducted Outdoor Units
Installation and Commissioning Guide - Standard Commercial Split Ducted Commercial Outdoor Unit
Doc. No.0525-056
Ver. 7 220308
7
INSTALLATION PREPARATION (Pre-Installation considerations)
The following items must be considered before beginning the unit installation:
•
Verify the unit capacities and ratings with the unit nameplate.
•
Make certain the floor or foundation is level, solid and has sufficient structural strength to support the unit and
accessories weight.
•
Allow minimum recommended clearances for periodic maintenance and service access.
•
Allow sufficient space above the unit for the outdoor air discharge. Condenser air inlet, located on the coil side of the
unit, requires sufficient airflow clearance for the optimum unit performance.
•
Note the conditioned supply air and return air location. Ensure sufficient spaces are allocated for these purposes.
•
For the connection and location of condensate drain in the unit, refer to the drawings and dimensions section of this
manual.
•
Wiring connections must be in accordance with the wiring diagram provided with the unit.
•
Make sure all wirings are in accordance with local electricity authority regulations and standards.
•
Do not install the unit close to an area where there is a danger of fire due to volatile, explosive, flammable and/ or
hazardous materials.
•
Ensure that spaces around the unit are free from any obstructions for optimum unit performance.
•
Installer to ensure correct size/type that main circuit breaker and cable is installed in unit sub-mains to protect the sub
mains and unit wiring.
•
Installer to ensure correctly rated Residual Current Device (RCD) is installed as per the latest edition of the AS/NZS
3000 (also known as Australian Wiring Rules).
•
Secure the power cords and control cables that goes in/out the unit. Use the cable ties provided in the control box.
NOTE
This outdoor unit is designed to match only with an ActronAir Series indoor unit as specified in the Technical Selection
Catalogue.
This unit is designed for use with R-410A refrigerant only.
The unit is supplied with factory charged R-410A refrigerant. Be aware of all the relevant regulations concerning the handling of
refrigerant.
All images in this document are for illustration purposes only.
05. Operation Manual Access
Download from website
C7-4
Operation manuals can be downloaded through our website shown below.
https://www.actronair.com.au/brochures-manuals/#operating-manuals
