ACU-RITE 02084, Instruction Manual

SETUP 

Install or Replace Battery 

1. Flip open the battery compartment. 
2. Connect 1 x 9V battery to the battery connector and insert into the  

    battery compartment, as shown. 
3. Close the battery compartment. 

1 

Open Battery 

Compartment 

Connect & Insert Battery

1 x 9V Battery 

2 

9V 

Select Temperature Units, Backlight & Laser Settings 

Once the unit is powered on, you may select temperature units, backlight and 

laser settings. 
To select between degrees Fahrenheit (°F) or Celsius (°C) temperature units, 

press and release the “°C/°F” button. 
To enable or disable the backlight, press and release the "  " button. 
To enable or disable the built-in laser sight, press and release the "  " button. 

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE 

WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS. 

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to 

be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of 

used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries 

in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT 

recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. 

2