5
AcuRite Iris Sensor Installation Guidelines
INSTALLATION HEIGHT
Mount the sensor at a minimum height of 5 feet (1.5 meters)
off the ground, in an open area. Higher is better for wind measurements - the National
Weather Service recommends 33 feet (10 meters) high!
MOUNTING OPTIONS
The included mounting bracket is designed to screw directly
onto wooden posts or surfaces that are 2”x 4” or larger. The sensor can also be mounted
directly to 3/4” steel pipe (available at hardware stores and home centers).
SOLAR CELL INSTALLATION
Install the sensor
with the
solar cell facing SOUTH.
This ensures
the cell receives as much sun as possible and
orients wind direction.
AcuRite Iris Sensor Installation
1. Fasten mounting base (included) to a post or
pole (not included) using the 4 longer screws
included in the hardware bag.
2. Insert the mounting base into the hole on the
bottom of the sensor.
3. Make sure the arrows on the top of the sensor
are pointed in the proper direction and the
bubble level is centered. The solar cell should
be facing south to properly orient the wind
direction.
4. Fasten the sensor into the mounting base
using the 2 shorter screws included in the
hardware bag.
The AcuRite Iris sensor is now ready to use.
Basic Setup is Complete
The AcuRite Iris sensor will now synchronize with the display. It may take a few minutes
for synchronization to complete. If both or one of the units appear to be functioning
improperly, please refer to the troubleshooting section.
SOUTH
(1.5 meters)
NO OBSTRUCTIONS
ABOVE OR AROUND
