Customising the system
9
ENTERING A NEW PIN WHEN A PIN IS
ALREADY KNOWN.
From time- time you may wish to change the
PIN that is in the system.
1. Disarm the system
2. Remove system fuse
(1 beep will confirm this)
3. Switch motorcycle ignition on. (1 beep)
4. Enter service mode (1 beep )
5. Press ‘key’ and ‘P’ buttons together on
the transmitter (1 beep)
6. Replace system fuse (1 beep)
7. Switch ignition off (1 beep)
8. Press ‘key’ and ‘P’ buttons together on
the transmitter (1 beep)
Enter your known pin; say 4 digits of 1234
Ignition on, count 1 beep, ignition off
Ignition on, count 2 beeps, ignition off
Ignition on, count 3 beeps, ignition off
Ignition on, count 4 beeps, ignition off
Now enter the new pin (say, 6789) by
Ignition on, count 6 beeps, ignition off
Ignition on, count 7 beeps, ignition off
Ignition on, count 8 beeps, ignition off
Ignition on, count 9 beeps, ignition off
Press the ‘P’ button on the transmitter.
You will now get one long tone, and you
will need to confirm the new PIN
Ignition on, count 6 beeps, ignition off
Ignition on, count 7 beeps, ignition off
Ignition on, count 8 beeps, ignition off
Ignition on, count 9 beeps, ignition off
The above example was for a PIN of 4
digits. If you want 5 or 6 digits, then you
need to choose 5 or 6 numbers before you
press the ‘P’ button on the transmitter, and
again when you confirm the PIN.
DISARMING THE SYSTEM USING
THE PIN OVERRIDE
If the system is armed and you cannot disarm it
from the transmitter, disarm using the PIN override
(in this example the PIN is set to 1234)
Switch on the motorcycle ignition and leave on -
the alarm will react... Let the system react for 30
seconds (until it stops).
The LED will illuminate for 5 secs and during this
time switch the ignition OFF
DURING THIS 5 SECOND PERIOD
Switch ignition ON - count 1 beep - ignition OFF
Switch ignition ON - count 2 beeps - ignition OFF
Switch ignition ON - count 3 beeps - ignition OFF
Switch ignition ON - count 4 beeps - ignition OFF
The system will now disarm - 1 beep and 1 flash
of the indicators, you now have 50 seconds to
start the motorcycle or the CAT1will arm again.
