General Installation Guide
4. Once the cables have been routed, test the power by plugging in USB power to
the device.
5. Once the reverse light’s power cable is found, use a multimeter to determine the
positive and negative wires of the reverse light power cable.
6. Attach the backup camera to the center area above the license plate and connect
the rear camera cable to the rear camera module. Connect the external GPS and
adhere the GPS Module to area on windshield that will not obstruct driver view.
7. Test the wiring by starting up the vehicle and check if the digital rearview mirror
displays rear view clearly, adjust rear viewing angle by swiping finger up and down
on the screen. Shift into reverse and check if the parking assist lines show, adjust
parking lines by swiping fingers up and down on the screen.
.
22
