Chapter 3___________________
Installation
3.1 Introduction to Touch Screen Controller Board
AcuDis115's touch screen is PenMount 6300 USB control board which is designed for USB interface
and specific for 4, 5, 8-wire touch screens. It is designed with USB interface features with multiple
devices supporting function. PenMount 6300 control board using PenMount 6000 controller that has
been designed for those who may like and all-in-one solution with 10-bit A/D converter built-in to
make the total printed circuit board denser, circuit diagram also designed for 12-bit ADC for optional.
There are two connectors on this board, one connector is for 4, 5, 8-wire touch screen cable
(optional), and another is for 4-pin USB A type cable (optional).
3.2 Windows 2000/XP/2003/Vista Universal Driver Installation
for PenMount 6000 Series
Before installing the Windows 2000/XP driver software, you must have the Windows 2000/XP
system installed and running on your computer. You must also have one of the following PenMount
6000 series controller or control boards installed: PM6500, PM6300.
3.3 Installing Software
If you have an older version of the PenMount Windows 2000/XP driver installed in your system, please
remove it first. Follow the steps below to install the PenMount DMC6000 Windows 2000/XP driver.
Step 1.
Please make sure your PenMount 6000 device had plugged in advance. If your device uses
RS232 interface, please plugged in before the machine is turned on. When the system first detects
the controller board, a screen appears that shows “Unknown Device”.Do not use this hardware
wizard. Press Cancel.
ACUDIS115 User Manual
9
