Multiple Monitors
Multiple Monitors supports from two to six touch screen displays for one system. The PenMount
drivers for Windows 2000/XP support Multiple Monitors. This function supports from two to six
touch screen displays for one system. Each monitor requires its own PenMount touch screen
control board, either installed inside the display or in a central unit. The PenMount control
boards must be connected to the computer COM ports via the RS-232 interface. Driver
installation procedures are the same as for a single monitor. Multiple Monitors supports the
following modes:
Windows Extend Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
NOTE:
The Multiple Monitors function is for use with multiple displays only. Do not use this
function if
you have only one touch screen display. Please note once you turn on this function
the Rotating function is disabled.
Enable the multiple display function as follows:
Step 1
. Check the
Multiple Monitor Support
box; then click
Map Touch Screens
to assign
touch
controllers to displays.
Step 2.
When the mapping screen message appears, click “
OK”
ACUDIS115 User Manual
16
