Chapter 4: BIOS Setup
IDE Configuration
This section is used to configure the SATA drives.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Advanced
SATA Mode
Configures the SATA as IDE or AHCI mode.
IDE
This option configures the Serial ATA drives as Parallel ATA
physical storage device.
IDE Configuration
Serial-ATA (SATA)
[Enabled]
SATA Speed Support
[Gen2]
SATA Mode
[IDE Mode]
Serial-ATA Port 0
[Enabled]
SATA Port0 HotPlug
[Disabled]
Serial-ATA Port 1
[Enabled]
SATA Port1 HotPlug
[Disabled]
SATA Port0
TOSHIBA MQ01AB (320.0GB)
SATA Port1
Not Present
Enable / Disable Serial ATA
→←: Select Screen ↑↓: Select Item
Enter: /-: Change Opt. F1:
General Help
F2: Previous Values F3: Optimized Defaults F4:
Save & Exit
ESC: Exit
AHCI
This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial-ATA Port 0
Enables or disables SATA port 0.
SATA Port0 HotPlug
Enables or disables hot pluggable support on SATA port 0.
Serial-ATA Port 1
Enables or disables SATA port 1.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Serial-ATA (SATA)
Enables or disables the SATA controller.
SATA Speed Support
Configures the SATA controller as Gen1 or Gen2.
SATA Port1 HotPlug
Enables or disables hot pluggable support on SATA port 1.
39
StockCheck.com
