13. On the
Calculate Route To
screen, select
OK
. The system then calculates a route and shows it as a blue line.
If you are in an area with unverified roads, you may see a blue vector line or a blue/pink dotted line pointing in
the direction of your destination.
14. Follow the voice guidance back to your dealership. It should work even with the audio system turned off.
15. With the map screen shown, check the system interaction with the audio system and the On Demand Multi-Use
Display (ODMD). Press and release the Talk button. After the beep, say “XM channel 115.” The ODMD should
show XM channel
115
.
16. With the map screen shown, check the system interaction with the climate control system. Turn it on by
selecting
AUTO
. Then press and release the Talk button. After the beep, say “Temperature 68 degrees.” The
ODMD should show 68 degrees.
17. Make sure the time shown in the navigation display is correct; the system gets it from the GPS satellites.
For areas that do not follow daylight saving time, you may have to adjust the time settings. Go to
Clock
Adjustment
in the
Setup
screen, and set
Auto Daylight
to
OFF
.
NOTE: If your dealership is near a time zone boundary, set
Auto Time Zone by GPS
to
OFF
. The clock then
keeps the home time if the client routinely drives across the time zone boundary.
18. Press the DISPLAY MODE button to make sure the display changes between the
Day
,
Night
, and
OFF
modes.
19. If the dealer traffic account is activated and if your dealership is near a metropolitan area that has traffic incident
or traffic flow data available (see ACURALINK REAL-TIME TRAFFIC INFORMATION), do this:
•
Turn the interface dial to select one of the traffic map scales (1/20-, 1/8-, 1/4-, 1/2-, 1-, 2-, or 5-mile).
•
Use the interface dial to scroll to the downtown area of your city. If your metro area has traffic flow data,
freeways and other main roads should show this data as red, yellow, or green lines in one or both
directions.
•
You may see small diamond-shaped traffic incident icons. If so, scroll over one and press in the interface
dial to see the details.
•
Partially shown traffic data does not mean a problem with the navigation system. Traffic flow and density
varies from day to day and from one road to another. If your area has traffic, but you cannot see it on the
screen, do an online search using keyword
TRAFFIC
.
20. Clear the HDD to delete any information that was saved during the TQI:
•
Set the power mode to ACCESSORY.
•
Turn on the audio-navigation unit.
•
Press and hold the MENU, NAV, and BACK buttons at the same time until the
Select Diagnosis Items
screen appears. Then release the buttons.
•
Select
Detail Information & Setting
, then
Functional Setup
.
•
Select
All Clear
. A confirmation screen appears, select
Yes
.
•
A second confirmation screen appears. Select
Yes
again.
4.
REARVIEW CAMERA
With the power mode set to ON, shift into Reverse. The rearview image appears on the navigation screen. Make sure
the distance guidelines appear on the screen. Change the camera views by pushing in on the interface dial. Turn the
dial to adjust the image brightness. This adjustment is not affected by the screen brightness adjustment in
Setup
.
NOTE:
•
When in Reverse, only the interface dial works; the other buttons are locked out.
•
If the image is foggy or dirty, clean the camera lens.
5.
TROUBLESHOOTING
If you think you found any problems with the navigation system during the TQI or after installing replacement parts to
repair it, go to the electronic service manual and enter keywords
HOW TO TROUBLESHOOT
. From the list, select
How
to Troubleshoot the Navigation System
.
Page
6
of
7
