ACURA’s
RX210 User Manual
Page 27 of 35
0x5 0x0 Network Receiver Node 0x0 Statu Checksum
Status = 0 - Report all tags
Status = 1 - Report only tags with an Alarm condition
Status = 2 - Report only tags without any Alarm condition
Get Invalid Tag Count
This command will return the number of Invalid Tags received by the RF module
since the last read. This data is calculated by the RF Module and is a direct
interpretation of tag collisions or read failures. This is a 2 byte value.
Command
0xA 0x00 Network Receiver Node 0x0F Checksum
Response
0x5 0x0 Network Receiver Node 0x0 Count_ Count_ Checksum
Count_H – Counter High Byte
Count_L – Counter Low Byte
Get Power Supply Voltage
This command will return the voltage of the power supply at this reader. It is a single
byte and represents the power in 0.1 voltage increments. Eg Value 131 = 13.1 Volts
Returns the voltage that the reader is receiving, via either its RJ45 ports or via the
2.5mm power socket. It will not return the voltage that it is receiving via the USB
socket if this option is being used.
Command
0xA 0x00 Network Receiver Node 0x10 Checksum
Response
0x5 0x0 Network Receiver Node 0x1 Voltage Checksum
Start Environmental Noise Level Value Calculation
This command will set the reader into an evaluation mode in order to calculate the
environmental white noise level at 433.92 MHz. The unit will remain in evaluation
mode for a time period of 40 seconds. During this period no tag transmissions will be
decoded. Once the calculation has been completed, the reader will resume normal
operation.
Command
0xA 0x00 Network Receiver Node 0x11 Checksum
Response
0x5 0x00 Network Receiver Node 0x11 Checksum
