8
1
Display Unit Setup
The display unit operates with batteries and/or power adapter. Regardless
of the power source, it is recommended that batteries always be installed to
ensure continuous operation (and retain records) in case of a power outage.
2
3
Set the A-B-C Switch
Install or Replace Batteries
The A-B-C switch is located inside
Insert 6 x AA alkaline batteries
the battery compartment. It can
into the battery compartment,
be set to A, B or C. However,
as shown. Follow the polarity
you must select the same letter
(+/-) diagram in the battery
choices for both the sensor and
compartment.
the display unit in order for the
units to synchronize.
Plug Power Adapter into
Electric Outlet
(optional)
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
2
Install Batteries
6 AA Batteries
3
Plug in Power
Adapter
(optional)
A B C
1
A-B-C Switch
set to match
sensor
Momentary
backlight during
battery power.
Backlight can always
remain on (or off)
when power adapter
is plugged in.
LIGHT
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
