Sailing Yacht SALONA 37
Sailing Yacht SALONA 37
Sailing Yacht SALONA 37
Sailing Yacht SALONA 37
AD BOATS ltd.
AD BOATS ltd.
AD BOATS ltd.
AD BOATS ltd.
Page of 80
63
∼
Give medium tension to the upper shrouds, pay attention to equal
lengths and secure them. The spreads should keep their given positions
and should not be pressed up or down by the shrouds.
∼
The fitting of the supplied furling stay is done according to the
manufacturer’s instructions (enclosed in the box). The completed furling
stay is fitted to the mast and secured.
∼
The shrouds should also be protected so that they cannot cause any
damage to the mast and its anodized coating when erecting the mast.
9.5
Preparation of the engine and propeller
∼
Check the oil level in the engine and gear, refill if necessary.
∼
Check the screwed connection of the propeller and its locking.
9.6
Launching
If the rails have not been fitted by the yard:
∼
Fit the bow pulpit and secure it.
∼
Insert the stanchions into the stanchion bases and secure them. Draw all
rails through the stanchions (with the strainers aft).
∼
Fit the cross-wires at the aft pulpit.
∼
Close all board ducts.
∼
Insert the transmitters of the speedometer and the echo sounder (if that
has not been done by the yard already).
∼
Fix sufficient fenders at the rails.
∼
Prepare the mooring lines.
∼
Pay attention to the instructions of the handling team during launching
with a travel lift. If a mobile crane is used, observe items 3.1 (unloading
the lorry).
Important
∼
To control the ships movements when hanging freely in the air, use two
lines; one fixed to the bow and the other to the stern.
∼
While using the crane, no one may be aboard the yacht.
NOTICE
NEVER
STAND
UNDER
PENDULOUS
LOADS.
